Use with 150mm x 150mm (6"x6") wood posts on decks, stairs, patios, concrete or any other hard surfaces.
A 1.75" dia. hole saw (1-7/8" inside depth) is required to prepare post with a circular pilot cut to guide cutting edge of tube which is then driven into anchor as shown in installation video.
Not recommended for older, drier wood (m.c. 12% or less)or with knots in lower 200mm of post. Works best with "green" new lumber with moisture content of 15%-25%.
Not intended for use with hardwoods or Douglas Fir unless hardwood installation techniques are used as indicated in directions. Hot dip galvanized and powder coated for superior performance.
Tested and approved according to IRC (AC273) and CBC building code procedures for use in residential guards for one and two family dwellings.
Must use specified fastener package (3/8x5 lag bolts and #14x3 screws) which are included in this package.
Max spacing between posts 1.8m.
NOTE: These anchors are suitable for 150mm x 150mm NOMINAL posts, or ~135mm x 135mm actual posts. Posts that are oversized must be planed down to suit or notched at the base to allow deck anchoring.
Watch installation videos to see how easy it really is:
|Post Installation||Concrete Installation|
A copy of the installation instructuons can be found here.
150x150 Post Anchor - All Hardware
- Brand: Titan Building Products
- Product Code: TIPR661B
- Availability: 75