Sold In Pairs

Our RailStrong rail connectors give you a clean looking rail to post connection with the added strength of a rigid hollow tube inside the 2x4 rail along side fasteners.

The top rail connector has a flat upper surface so you can lay a flat 50mm x 100mm over top edge of another horizontal rail member.

You can use our 50x100 center guide to quickly locate the center of your 2x4 and plunge the hole saw to a depth of about 1-1/4” - just short of the length of the tube on the RailStrong connector. Tap set the tube into the end of the post and finish up with two screws.

Hot dip galvanized and black powder coated finished for superior longevity and compatible with ACQ lumber. Uses the same innovative tube technology concept as our post anchor.

NOTE: These anchors are suitable for 50mm x 100mm NOMINAL posts, or ~40mm x 90mm actual posts. Posts that are oversized must be planed down to suitto allow  anchor insertion.

50x100 RailStrong Top Rail Kit (Pair) - All Hardware

  • NZD$16.85
  • NZD$12.50


Related Products

50x100 Center Guide

50x100 Center Guide

Galvanized finish. Locate the center of posts for your hole saw fast, easy and with virtually no..

NZD$3.36

50x100 Hole Saw Kit

50x100 Hole Saw Kit

Use this 19mm (3/4") diameter hole saw and arbor to prepare the ends of 50mm x 100mm rails for use w..

NZD$25.95

50x100 RailStrong Bottom Rail Kit (Pair) - All Hardware

50x100 RailStrong Bottom Rail Kit (Pair) - All Hardware

Sold In Pairs Our RailStrong rail connectors give you a clean looking rail to post connection wi..

NZD$12.50 NZD$16.85